ASK wrote:bloodflowers wrote:Nearly ready to use... Girlfriend is happy the kitchen no longer contains a solder station.
Nice setup! What make is the scope (looks new rather than used)? How much did it run you?
It's a Philips/Fluke PM-3084. It is used but not terribly old (tiny amount of plastic yellowing, you can only tell looking closely from the top edge), I picked it up on ebay for less than they generally cost, £160 I think. It's 4 channels at 100mhz, I was told I'd only really need two but in fact I found a really good use for all four only recently, so it was definitely worth it. The automatic setup button is also really useful - saves time when you first switch it on and need to find the trace, just connect the probe(s), hit auto, and then look at the results.
This is a Rastan board I fixed, lower 3 channels are samples/left FM/right FM, top channel is the mixed output after the resistor array.
http://www.system11.org/temp/rastan_pre-IC106.jpg