I am new at soldering and ran into trouble on a GBS control project.
I had some solder bridging across R34 & C33 on a GBS 8200 v4.0 board. When I wicked away the solder, it looked like the to points were bridged at the board level. The connection does not look organic. Can anyone confirm with a continuity check across the two points on a known good board?
Maybe its, good that I ran into a problem. I did notice the piece of foreign mat'l to the right in the picture between C31 & C32 on the magnified image.
https://www.dropbox.com/s/jg6vux9sqo9v8 ... e.png?dl=0
Thank you in advance for any help.