Framemeister + TurboGrafX - RGB MOD - no Picture

[BlutIstGut]

Hello,
after a lot of reading and afterweards buying the equipment i now have a problem with my Framemeister.
My System is:
XRGBMini Framemeister
Sony KDL 50W656

Every Console I connected up to now works:
SNES + RGB Cable - Good Picture
MegaDrive + RGB Cabel - Just Pervect
Playstation 1 + RGB - Very Good
Playstation 2 + Componetn - Very Good
NES - Composite - mediocre
PS 3, PS 4, Xbox One, WiiU, WII directly to the TV

Today i got my new TurboGrafX 16 with RGB Mod - the Cable runs directly out of the Box.

Tested it with my Framemeister - Blue Screen "No Picture" - Sound is there.
With RGB on my old 55 cm Grundig CRT - very good Picture - sys RGB on the Screen on Connection, so I think the Cable ist correctly wired for RGB
So i feared testing it directly via RGB - Scart on my Sony - Done it - Whoa - near perfect Picture, but of course no Scanlines..

So i do have to mention all my Consoles are Pal - I am from Austria - except for the TurboGrafX.

So what could the Problem with the connection to the Framemeister be?

[amaradona]

Have you tried to fiddle with the sync settings?

[broken harbour]

I had exactly the same problem.

Using this fixed it: http://www.ebay.ca/itm/Micomsoft-XRGB-M ... 25a0dfb126

There's also a female Scart version if that's what you need.

[BlutIstGut]

Thanx for your answers, last nigth i had some time for testing.

Fiddling with the sync didnt change anything - but i really dont know what to change so i tried.

For the Cables, i own an EuroScart - Female to Framemeister Cable with built in SyncStripper form RetroCalbes.co.uk, so I dont know if there is a difference to the Cable u listet above, maybe u can tell me.

I crammed out my od DVDO IScan HD, pooped it ub via Euroscart YUV - Cable and also got picture, but it was much worse than directly into the Sony (a lot sharber, with Fast Screen Deinterlacing turned off, gives u 1 frame lag, but that would the framemeister also do...).

Regard

Andreas

[BuckoA51]

Does your EuroScart female to Framemeister cable have a piggy-back power connector that plugs into the Mini?

[BlutIstGut]

No, it doesn t have, a sticker says that power should be on pin xx, im not at home, so i cant read it exactly...

[BuckoA51]

Probably the sync stripper is not getting enough power then, happens all the time. Disconnect the sync stripper internally or buy one of the adapters with the piggy-back power. I'd go for the latter as I still believe some systems benefit from having the sync cleaned.