snes csync SCART no picture

[wyvernshill]

Lo everyone, i got a modded supercic super famicom (1chip) and bought a ntsc snes scart with csync. The audio passes without issue, but i have no image at all.
I connect the snes to my framemeister by using a euroscart cable to the framemeister.

Basically:
Normal ntsc scart + normal euro framemeister scart = good picture.
Normal ntsc scart + sync stripper built in euro Framemeister scart = only audio.
CSYNC ntsc scart + normal euro framemeister scart = only audio
CSYNC ntsc scart + sync stripper built in euro Framemeister scart = only audio

Does anyone know why i cannot use csync or a sync stripper ?
I got the framemeister euro scarts from retro gaming cables in the uk.
The scart cables came from the woman on ebay everyone keeps recommending.

Thanks.

[ApolloBoy]

It looks like you may have the 1chip revision that lacks composite sync output. Not a big issue though, just add a wire from pin 7 of the video encoder to pin 3 of the multiout and you should get video.

[blizzz]

I assume the sn on your console starts with S252....., correct? If you open up the console and it says 1CHIP-03 on the motherboard you have the revision that doesn't have c-sync connected to the multiout. As ApolloBoy already said, it's just a matter of connecting the pin from the encoder to the output.

[FBX]

It looks like you may have the 1chip revision that lacks composite sync output. Not a big issue though, just add a wire from pin 7 of the video encoder to pin 3 of the multiout and you should get video.

I modded mine via this method:

http://blake.remoteshell.org/consoles/s ... HIP-03.png

The wire is only about a half-inch long this way, and was pretty simply to do.

Also want to point out the OP can find out if they have the -03 revision by looking on the motherboard itself underneath the front flange (you'll need to obviously unscrew the flange to remove it).

[mvsfan]

It looks like you may have the 1chip revision that lacks composite sync output. Not a big issue though, just add a wire from pin 7 of the video encoder to pin 3 of the multiout and you should get video.

I modded mine via this method:

http://blake.remoteshell.org/consoles/s ... HIP-03.png

The wire is only about a half-inch long this way, and was pretty simply to do.

Also want to point out the OP can find out if they have the -03 revision by looking on the motherboard itself underneath the front flange (you'll need to obviously unscrew the flange to remove it).

That method works fine ive restored Csync on a few 1-chip-03's that way.