The main feature of this card is the ability to capture 15KHz RGB signals
when used with the X-SYNC1 (sync H/V splitter). It can capture (concurrently!)
component video, HDMI (without HDCP), DVI (without HDCP), and analog VGA.
Testing notes:
- Switch on the bottom set to OFF.
- USB power cycle needed sometimes for video detection.
- 220uF capacitors on the RGB lines.
Strikers 1945
Result: OK
Strikers 1945 II
Result: OK
Strikers 1999
Result: OK
Cyvern (Kaneko SuperNova)
Result: OK
Darius Gaiden (Taito F3)
Result: OK
Fire Shark (Same! Same! Same!)
Result: OK
Note: 57.6 Hz
G-Darius Ver. 2 (Taito FX-1B)
Result: OK
Battle Garegga (Toaplan base?)
Result: OK (Minor screen cutoff at bottom)
Gradius IV (Hornet)
Result: OK (Screen cutoff at left)
Note: 24 KHz, 58 Hz
Raiden (Main Set)
Result: OK
Raiden (Alternative Hardware)
Result: OK
Note: Sync signal rather finicky, works on XRGB-2 in PCB mode
Raiden II
Result: OK (Minor screen cutoff at bottom)
Note: 55.5 Hz, works on XRGB-2+ but not XRGB-2
Raiden DX
Result: OK (Minor screen cutoff at bottom)
Note: 55.5 Hz, works on XRGB-2+ but not XRGB-2
Raycrisis (Taito G-NET)
Result: OK
Recca (RGB modded NES)
Result: OK (Jailbars inherent in NES RGB mod)
Vasara 2 (SSV)
Result: OK
Viper Phase 1 (Seibu SPI)
Result: OK (Note 54hz)
Viper Phase 1 NV (Seibu SPI)
Result: OK (Note 54hz)
Blazing Star (Neo Geo MVS)
Result: OK
Micomsoft is actively developing the driver so currently
unsupported boards may be fixed in the future.
