Guwange PCB Size Question

Geezer · Post by **Geezer** » Wed Feb 28, 2007 12:20 pm

Does anybody know its dimensions?

Geezer

sven666 · Post by **sven666** » Wed Feb 28, 2007 2:28 pm

if its any help its the same size as all the other cave/atlus boards..

GaijinPunch · Post by **GaijinPunch** » Wed Feb 28, 2007 11:03 pm

A moderate amount of inches by a lot of inches. it's pretty big.

Dreadzone · Post by **Dreadzone** » Thu Mar 01, 2007 9:05 am

Mine is 28 x 23.5 cm

DZ

Geezer · Post by **Geezer** » Sun Mar 04, 2007 9:06 pm

Many thanks. I was asking as I want to pick up a board and consolize it in the near future

iatneH · Post by **iatneH** » Mon Mar 05, 2007 10:59 pm

Oh goodness, please don't.

At the very least, plug in a 28x2 edge connector and consolise THAT... Hmm... basically ending up with a compact supergun, but please don't wreck the board..!

Geezer · Post by **Geezer** » Mon Mar 05, 2007 11:18 pm

iatneH wrote:Oh goodness, please don't.

At the very least, plug in a 28x2 edge connector and consolise THAT... Hmm... basically ending up with a compact supergun, but please don't wreck the board..!

Why would I wreck the board?
All I need to do is plug a jamma connector to the board and do all the wiring as though I was making a supergun, just with the board installed inside the case. That way the board can be removed easily and will be fully intact

You didn't think I wanted to solder directly to the PCB? There's no way I'd ever do that

iatneH · Post by **iatneH** » Mon Mar 05, 2007 11:35 pm

OK, so basically a supergun with a compartment to store the JAMMA board then? That's a relief.

Just usually I thought consolize meant direct modifications to the JAMMA board.