Genesis 2 RGB cable mod required.

neorichieb1971 · Post by **neorichieb1971** » Wed Sep 06, 2006 3:27 am

If anyone on this forum can modify my Genesis 2 RGB cable so that RGB is displayed in a non-overly-bright fashion I would appreciate it.

Paypal ready and waiting.

Thankyou.

Richie.

Specineff · Post by **Specineff** » Wed Sep 06, 2006 5:44 am

Dude, just get a soldering iron, and three 75 Ohm resistors. and solder them in series one on each of the RGB lines. Piece of cake.

neorichieb1971 · Post by **neorichieb1971** » Wed Sep 06, 2006 5:52 am

I assume you mean the R G B lines inside the cable right?

So just get the gamesx.com pinout and put 3 75ohm resistors in there?

neorichieb1971 · Post by **neorichieb1971** » Fri Sep 15, 2006 4:38 pm

I used 100ohm on the RGB lines since I couldnt find any 75ohm.

Works just the same I think, I sense a tad darker screen but the XRGB takes care of that with the amount of twiddling you can do. I'll change them to 75's later