I have a question for experienced WiiDual installers--has any one else lost composite video after an install (excluding cases where composite was disabled for csync)?
I installed a WiiDual 1.1 in a Japanese 06 Wii today, and I had hoped to keep both composite video and D-terminal video functional. I mostly wanted WiiDual for HDMI output.
This is my install.
When I tested my install, HDMI video worked fine. D-terminal video worked fine (before I removed Q7 and R55). However, I have no composite video. I kept the components along the path to composite out that are removed when using composite csync, and did not short any jumpers initially.
I later wondered if perhaps "No Where (Only Component Video and RGsB will work) - Do NOT short anything" on the install page could mean that if no jumper is shorted, then composite video will not work, so I removed Q7 and R55 and shorted jumpers 1 and 2. However, this brought no change.
I just see a brief white flash over composite, then nothing.
I think my install is clean, so I am not sure what may be going on.
Edit: my WiiDual is from the most recent batch, so I think it has FW 3.0e.
Any ideas? Is there a firmware setting I am missing perhaps?
On a related note: is s-video necessarily lost when using the WiiDual? There is a comment on the v2 YouTube install video where someone asks "I hope someone can help me with a question, if I plan on using HD RETROVISION Wii YPbPr Component Cable and hdmi would I still need to remove components or can I just install the mod. And if so which ones (the same that are remove here? Or less?)" and citrus300pri replies "No components would need to be removed if you only plan to use YPbPr."
So if I wanted to use YPbPr over a D-terminal cable, I could also leave those components in? And I would still have s-video?