Made a stupid mistake, can anybody repair?

[Hubz]

So I was reorganizing my stuff today and re-hooked up my OSSC and GScartSW but accidently switched their power cords around since they look quite similar. Anyhow upon doing so they both are no longer turning on. I don't know if this is fixable but I'm going to be sick if the quick mistake I made is going to end up costing me frying almost $500 in parts.

[Syntax]

OSSC takes 5v dc center +
GScart takes 7-12 dc center +

The GScart should be fine still.

May of blown a diode in the OSSC.

[Hubz]

Weird the GScart is non-responsive as well. No light or anything... I am not an electronics wizard but I can do some basic soldering so is a diode usually what pops when power is incorrectly supplied? Maybe I can try replacing it and seeing what happens.

[Hubz]

Sounds like I can replace D5 and F1 and that might fix me from other posts I read. I'll order and try that for the OSSC. Just need to figure out what to try replacing on the gscart.

[djc5166]

I did the same thing with my setup, but it only killed the OSSC.

Just had to replace the one zener diode (D5 in the schematic) in the ossc, my gcomp was unaffected.

[mvsfan]

THIS is why they should have switched to usb power cords a Long time ago, like they are doing now.

the old power supplies are many voltages, with the same tip a lot of time.

Result: fried electronics.

Ive done it too.

[Hubz]

Glad to know I'm not the only one. But I'll be MUCH more careful from now on.

Sent my GScart to SuperG today in order for him to take a look at it. Hoping it's nothing major.

[Hubz]

Just in case anyone else has this issue replacing the diode did fix the OSSC. Thanks for the advice!

[Syntax]

Whats the verdict on the scart switch?