I have a BVM D24 setup for my RGB consoles and component consoles. The image for both RGB and component is good, however on 480i video mode I have a few individual red video lines that loop across the screen. When an RGB video signal is shown the lines are only really noticeable at the screen border but when not video is connected and a black screen shown then the lines are visible. It's more of a minor annoyance than anything else. The lines are not shown on 720p component output (Xbox 360 / PS3) just 480i. Any ideas on what the cause might be and if any of the monitors components could be replaced or repaired. I'm based in Oxford, UK.
Thanks
John
Problem with BVM-D24E1WU
-
philexile
- Posts: 425
- Joined: Fri Feb 26, 2010 8:22 pm
Re: Problem with BVM-D24E1WU
Oops, thought this was a new post - sorry! 