Sony BVM 1910 Help

[mazdababy]

This is my first post but I've been lurking around for a while collecting information for my setup.

I've begun my quest for RGB awesomeness. I picked up some quality scart cables, two shinybow 6x2s (daisychained), BNC cable, and a Sony BVM 1910.

http://i.imgur.com/kOEXfVE.jpg

I've tried figuring out how to adjust it myself and I've done okay. Image is pretty centered and straight, convergance looks fine. Waiting on my Toro to come in so I can run the 240p suite.

http://i.imgur.com/hUBt6Pr.jpg

However I have one issue I think I've ruled out that can be controlled by the remote. The top right corner of the screen seems to be pulled further toward the center than the other three corners. I've done the best I can to make it look OKAY but I think it may be a cap issue? But I really don't know much about these yet.

it's the top right corner of the screen, and the bottom right seems to bow a little, too.

http://i.imgur.com/1wgy8nm.jpg

Thank you!


Also, I'm located in NE Georgia if anyone nearby is knowledgeable that likes beer & pizza

[mazdababy]

bump?

[samysnes]

Hey there! Do you still use that BVM-1910? I am considering picking up one myself but I had some questions about it that the seller can't answer. I was hoping you could help me out Oh and sick setup BTW!