espgaluda pcb - full auto?

japtor · Post by **japtor** » Tue Feb 07, 2006 4:37 pm

so who knows how to actually use it? is it A+C like esprade or some other voodoo magic? or does it do a slightly different shot, like ketsui? (iirc you can tap C to get a short quick stream of shot, when A gives a long stream). or is it there as a useless option just to confuse and mock me?

zaphod · Post by **zaphod** » Wed Feb 08, 2006 6:20 am

Should be just like esprade's full auto, which is simply hold button c. it shudl rapid fire the normal shots without activating a charge shot or slowing your movement.

japtor · Post by **japtor** » Fri Feb 10, 2006 8:44 am

in both esprade and galuda, c is used for the guard barrier.

i tried combinations of all the buttons and nothing works. any chance galuda supports a 4th button?

Post by **Dave_K.** » Fri Feb 10, 2006 9:02 am

The ESPGaluda PCB supports the 4th jamma button as full auto. Strangely enough, it even works when you do not have the option enabled in the settings.

SAM · Post by **SAM** » Sun Feb 12, 2006 5:32 am

Than how about esprade's full auto, I don't notice any difference.

zakk · Post by **zakk** » Sun Feb 12, 2006 6:15 am

SAM wrote:Than how about esprade's full auto, I don't notice any difference.

The autofire setting in esprade is only active when you're holding A+B.

With full auto OFF, it will wait for your b-shot 'meter' (down in the lower left corner if you're using 1p side) to fill back up to max before it lets off another full b-shot.

With full auto ON, it lets out a b-shot as soon as the 'meter' starts to fill up again. Basically the difference between the two is that with it OFF you will shoot a full power b-shot out every 1.5 seconds or so. With it ON you'll shoot small bursts of b-shot constantly.