Deathsmiles PCB Eproms message 33E

[K-2]

As far as I can tell my Deathsmiles pcb plays perfectly, but at the startup when it checks the eproms it comes up with a message of "33E"

Anybody know what this means?

Is it normal?

[Layer]

You should post a pic of it

[Monstermug]

33E is the last data line of the check. All Deathsmiles pcbs checks up to this line. Maybe only reason you see just this and not the previous checks leading up to it is because your monitor takes time to warm up?

[K-2]

Thanks monstermug!

I should have said that I see the previous check screen and all says "OK!!"

I just saw the letter "E" and immediately thought it might stand for "Error"

Thanks again!