SkyFox PCB weird issue

yojo! · Post by **yojo!** » Wed Jun 10, 2015 5:52 am

I'm noticing something weird on my SkyFox PCB. With SW1's dipswitch #7 is off , the game plays fine except that the screen is upside down. When I turn it on, the screen is now oriented correctly but Player 1's joystick does not register anymore; instead player 2' joystick now acts as player 1. Can anyone owning the board verify this ? This does not match MAME behavior (where P1 registers regardless of SW1's Dip7 settings) so I am wondering if my PCB is defective...

Post by **system11** » Wed Jun 10, 2015 3:28 pm

Cocktail mode, switch on the end next to it.

yojo! · Post by **yojo!** » Sat Jun 13, 2015 3:37 am

Tried that and this has no effect on input detection. coin in and start are always detected and joysticks and fire 1 and 2 are not, regardless of dip #8 setting. As soon as I switch dip #7, the joystick registers but the screen is upside down...

Post by **system11** » Sat Jun 13, 2015 10:47 am

Does the adapter have both sets of controls hooked up properly? Photo of PCB?

shmups.system11.org

SkyFox PCB weird issue

SkyFox PCB weird issue

Re: SkyFox PCB weird issue

Re: SkyFox PCB weird issue

Re: SkyFox PCB weird issue