BNC ports on the PVM 1910 too far apart

[Drjebus]

Unexpected difficulty in my quest to mod my N64 for RGB: the SCART <-> BNC cables don't fan out enough!

I've been looking around, and I can't find BNC Male to BNC Female extension cables.

Here's what I did find:

BNC male to male extension cables

BNC female to female couplers

If I terminate the SCART <-> RCA cables with these female couplers, then add the male to male BNC extension cables to get from coupler to BNC ports on the PVM, will I preserve the RGB video signal?

[yojo!]

Uhm, I have 1910s and I don't have any issues the BNC to SCART cable from http://www.retrogamingcables.co.uk/sony-pvm.html. It's tight but it works. Also you may also want to go width the 25pin connector if you think the BNC isn't working out for you.

[gray117]

It'll be fine as long as the cable doesn't get super long. Your solution seems fine.

Most common solutions usually involve regular phono cables and then bnc adapters - you might find shorter phono cables about if you're worried about cable mess.

If you experience any issues try keeping the [now longer cables] away from clusters of power cables - but you really need a lot to cause any noticeable interference, never had this issue at home.

[Drjebus]

Thanks for the feedback. Also, yes, the cables *do* reach, but only just barely, which makes me feel uncomfortable >_>

BUT, if I don't run any risk of damaging my cable with the tightness, I'll just leave it as is.