Supergun and XRGB mini help

[slai50]

so I have a supergun with a Neobitz encoder and just can't get in to work with my XRGB mini and Samsung LED TV. I get a message that says "no input". I have tried the same setup on 3 other LCDs and get the same message. I'm pretty sure everything is hooked up correctly. When I bypass the xrgb and just use component cables I am able to get a picture. would changing my supergun video encoder to a Jrok help? any other suggestions?

[cyborc]

have you tried bypassing the encoder and just using rgb? I don't really see the need to use component with the mini if you have a device that can output rgb.

[slai50]

have you tried bypassing the encoder and just using rgb? I don't really see the need to use component with the mini if you have a device that can output rgb.

my supergun outputs both RGB and component. I was using RGB scart cable with the xrgb mini when I was getting the "no input " message. I then tested with component cables without the xrgb mini and got a picture. But I want to use the xrgb mini so I can enable scanlines. anyother suggestions?

[Fudoh]

Did you try the full sync level range you can adjust on the Mini ? If this doesn't work, I would still suggest bypassing the encoder - in case the RGB signal gets routed through it.

[slai50]

Did you try the full sync level range you can adjust on the Mini ? If this doesn't work, I would still suggest bypassing the encoder - in case the RGB signal gets routed through it.

how do I adjust the sync level? all I see in the menu is sync auto and sync off.

[Pasky]

Scroll down further in the same menu that has sync mode. Sync level is towards the bottom.