neorichieb1971 wrote:
Sounds like you would need to set something up on the menu. I doubt digital and analog signals would be converted at the exact same time.
Correct--the XRGB-3 cannot output through both the digital and the analog at the same time. You probably just have to change the output from the VGA to the DVI in the settings. Try messing around with some of the relevant translated settings.
and to InkVisitor, thanks! I can READ now =)
Here goes:
First picture
Guideline
Off / On
Second picture
PC Match
(Grey) Cancel the PC Match implementation
Third picture
NTSC Dot Lock
Standard / Manual
Fourth picture
NTSC AFC
Automatic / Manual
Fifth picture
Drawing method
Interlaced (fake scanlines) / Non-Interlaced
Sixth picture
D Terminal input #2 setting
Component / Seperated(?) / Composite
Seventh picture
RGB input setting
Component / Composite
Eighth picture
RGB input terminal
75 Ohms / 220 Ohms
Ninth picture
Power settings
Standby / Always On
Tenth picture
Y/C Seperation Setup
Automatic / Low-pass
Eleventh picture
Horizontal Sync Polarity
Passthrough / Inverted
Twelfth picture
Vertical Sync Polarity
Passthrough / Inverted
Thirteenth picture
Screen Display Mode
Automatic / XGA / SXGA / UXGA
Fourteenth picture
Passthrough input setting
Automatic / Analog / Digital
Fifteenth picture
Current Screen Status
1024 x 768 Dots