Here's my question. If I have a SC200 Jameco PSU which feed 5v at 4 amps, and I'm running a CPS2, a set of sanwa flash sticks (again +5 volts, not sure on the draw) and a single or set of 8 ohm speakers will I have enough juice with this PSU or am I fucked and forced to use a PC or Arcade PSU.
Thanks
Power Supply question
-
thchardcore
- Posts: 483
- Joined: Wed Jun 22, 2005 9:20 am
- Location: Liberal cesspool
Power Supply question
A camel is a horse designed by a committee
-
neorichieb1971
- Posts: 7680
- Joined: Wed Jan 26, 2005 1:28 am
- Location: Bedford, UK
- Contact:
Speakers are not a draw, the amp in the PCB itself will need to be powered regardless of speakers attached.
As I told you before the SC200 is not a prime candidate as it does not support -5V.
I believe the SC200 can power some 4 slots, so most games will work fine. To be honest I don't see a problem at all.
Oh, and if your parrallelling the speakers I was wrong, you need 2 4ohms to get an impedence match.
As I told you before the SC200 is not a prime candidate as it does not support -5V.
I believe the SC200 can power some 4 slots, so most games will work fine. To be honest I don't see a problem at all.
Oh, and if your parrallelling the speakers I was wrong, you need 2 4ohms to get an impedence match.
This industry has become 2 dimensional as it transcended into a 3D world.