So here is the project:
I have a Dynamo HS-27 cabinet that I'm looking to run Raiden 2. The monitor is a WGD9200.
When I plug the Raiden 2 PCB into the Jamma harness the monitor simply displays "Out of range". I'm having trouble finding anything on why this isn't working correctly. I'm at a complete loss. The board has been confirmed to work, and on paper (unless I'm missing something obvious) it is fully compatible with this monitor.
Any help?
Raiden 2 PCB - Out of Range with WG D9200, help requested
-
plasticfactory
- Posts: 15
- Joined: Tue Oct 03, 2017 5:46 pm
-
daskrabs
- Posts: 257
- Joined: Sat Oct 01, 2011 1:05 pm
- Location: Philly Area
Re: Raiden 2 PCB - Out of Range with WG D9200, help requeste
That board has an odd 54KHz vertical refresh rate. You may need to adjust the VSYNC rate on your monitor if possible.
-
plasticfactory
- Posts: 15
- Joined: Tue Oct 03, 2017 5:46 pm
Re: Raiden 2 PCB - Out of Range with WG D9200, help requeste
Unfortunately I do not believe I can.daskrabs wrote:That board has an odd 54KHz vertical refresh rate. You may need to adjust the VSYNC rate on your monitor if possible.
-
hanasu
- Posts: 129
- Joined: Fri Nov 29, 2013 7:24 pm
Re: Raiden 2 PCB - Out of Range with WG D9200, help requeste
IIRC the 9200 has a jumper connector bit on the back of the frame to select resolution - are you sure you're actually in 15k mode?
-
plasticfactory
- Posts: 15
- Joined: Tue Oct 03, 2017 5:46 pm
Re: Raiden 2 PCB - Out of Range with WG D9200, help requeste
The D9200 has a board that automatically detects/switches resolution. However, I've read that that board tends to fail. I will poke around and see if there is a connection to manually change. Thanks for the tip, this gives me something else to look for.hanasu wrote:IIRC the 9200 has a jumper connector bit on the back of the frame to select resolution - are you sure you're actually in 15k mode?