(https://twitter.com/voultar/status/1086 ... 36?lang=en) and the github page for the IGR project (https://github.com/borti4938/NES_IGR_fo ... stallation), but that just has some pictures that aren't very clear. I am pretty sure I have most of the wires soldered to the same place as Voultar's picture, but I can't tell what the RO wire is connected to in that picture. I also soldered the 5v and 3.3v to the points labeled on the github page and I have used a multimeter to verify they are getting the correct voltage. I think it is either the resistor R5 or the capacitor C15 but I have tried both and had the same issues. Has anyone successfully installed one of these or does anyone know where to get cleared instructions?
Here is a picture of what I have so far.
https://imgur.com/a/wIJIhsm
Edit: I have done some further troubleshooting, the cycling palates seem to be caused by wiring on the reset circuit. When I disconnect the reset wires from the NES RGB IGR board the pallets stay where they are supposed to be unless I use controller inputs to change them. I suppose I will have to try to figure out what the github is trying to convey for setting up the reset wiring now.
edit 2: I figured it out myself. A working method to wire up the reset is to connect the RO wire (not RI as shown in Voultar's picture) to pin 4 of the power/reset connector on the motherboard, desolder the yellow wire from the power/reset board, and solder a wire from RI to the pad where the yellow wire was connected. Be careful and plan ahead for wire routing, the bottom rf shield will get in the way if you don't.