Defective BKM-24N?

[nissling]

So my BVM-20F1 has a BKM-24N board installed on slot 2. It is detected by the monitor yet I cannot get any image at all from it no matter if I use composite or YCbCr (haven't tried Y/c yet but I doubt it would make a difference). I knew that the previous owner couldn't get it to work when I bought it so it wasn't a surprise by any mean.

Any ideas what to do?

[Guspaz]

On BVMs, you must specify the type and format of the signal being fed to each connector in the menu (on the INPUT CONFIGURATION menu), and you need to terminate the outputs. Did you make sure to do both? That said, I'd expect it to still work without being terminated, just with excessive brightness.

[nissling]

I've done both and tried out various inputs. Still nothing, just a black screen.

[nissling]

I've changed the slot as well as input with no further results. Any idea?