Micomsoft SC-512N1-L/DVI + SyncStrike = ?

[SnakeGrunger]

Hi,

As the subject states, I have an NESRGB modded console, plugged into an ArcadeForge SyncStrike with Scart cable, then plugged into the VGA input of my SC-512N1-L/DVI capture card. I get a nice video signal, but it's only 30fps. I don't know which setting to change to get the best 60FPS input possible. Any advice ?

https://youtu.be/hj_pKBlVNPk

Here's a desktop video capture showing my current setup with AmarecTV 3.1 and the latest Micomsoft drivers. Is there an alternative to Amarec that could give me the best results ? I tried Videokeeper2 but, results are worse visually, and 30fps as well. Are there settings in the capture drivers I am not using correctly ?

Thank you!

[Fudoh]

If you have a look at your signal status at 00:12 in the video, you see that is says 480i60.

The software deinterlacer in your capturing app turns that into 480p30, so that's your result. You can see in your video that the app ignores your "weave" setting.

[SnakeGrunger]

If you have a look at your signal status at 00:12 in the video, you see that is says 480i60.

The software deinterlacer in your capturing app turns that into 480p30, so that's your result. You can see in your video that the app ignores your "weave" setting.

I'll have a look into that. Also, I was told that the latest Micomsoft drivers screw up 240p capture, and that I should do a rollback. I will try both alternatives and post a conclusion.