Last night my OCD went mad so I played around in service menu of my Sony PVM 20m2MDU and screwed up. I cannot get descent picture, settings are all over the place
Can someone help, I will paste what settings I need, you can enter yours here, then get a starting point from where I will restore calibration settings.
The problem was - I couldn't get good calibration with my PC and also with my 60HZ NTSC Genesis (originally RGB but with 60HZ switch).
They are both connected with PVM trough scart. I managed to get a fine looking picture for them individually, but when I change input from PC to Genesis or vice versa, picture was not centered right. Should over scan be used in that situation?
NOR 50 DEF-H FREQUENCY
NOR 50 DEF-VIDEO PHASE
NOR 50 DEF - V SIZE
NOR 60 DEF H FREQUENCY
NOR 60 DEF VIDEO PHASE
NOR 60 DEF V SIZE
NOR 60 DEF V CENTER
NOR DEF H SIZE
NOR DEF PIN PHASE
NOR DEF PIN AMP
NOR DEF LOWER PIN AMP
NOR DEF UPPER PIN AMP
NOR DEF SEXY
NOR DEF V LINEARITY
NOR DEF V BOW
NOR DEF LOWER V BOW
NOR DEF V ANGLE
U/S DEF V SIZE <50>
U/S DEF V SIZE <60>
U/S DEF H SIZE
U/S DEF PIN PHASE
U/S DEF PINAMP
O/S DEF V SIZE <50>
O/S DEF V SIZE <60>
O/S DEF H SIZE
O/S DEF PIN PHASE
O/S DEF PN AMP
OTHER LANDING
OTHER SPLIT PHASE
OTHER V HOLD
OTHER H BLANKING
OTHER V BLANKING <50>
OTHER O/S UPPER V BLK <50>
OTHER O/S LOWER V BLK <50>
OTHER V BLAKNING <60>
OTHER O/S UPPER V BLK <60>
OTHER O/S LOWER V BLK <60>
OTHER HP POSITION
OTHER HP WIDTH
Thanks in advance, you will save my ass I hope.
Regards!
