N64 Ultra HDMI issue with analog out on HW1

The place for all discussion on gaming hardware
Post Reply
nohomo64
Posts: 1
Joined: Sun Jul 25, 2021 6:50 pm

N64 Ultra HDMI issue with analog out on HW1

Post by nohomo64 »

I am seeing a zoomed in picture only through my capture card. normal lcds wont pick up the unusual signal. I tried the test point, reflashing firmware 1.08 hw1 and doing the default button combo and holding reset. Does anyone here jtag flash n64 Ultra HDMIs?
I believe I made the mistake of 1. Flashing HW2 to my HW1 board and, 2. I turned on direct mode and then turned on Analog out. I did that to my HW1 in trying to get the HD Fury 2 HDMI to Component converter to see it. I, however, did not know it was the wrong HW version of the Ultra HDMI.
this is a picture of what I can get:
[https://www.facebook.com/groups/FPGA.Re ... 5601306131[
The only place I can see any video from the Ultra HDMI is through my PCi HDMI capture card and it is zoomed into the upper left corner. The OSD will not appear and I am rather positive the reset to defaults combination and reset button didn't work I tried them together too.
Post Reply