I redesigned an old Phillips Videopac G7000 rgb mod I had here. It became this small poststamp sized pcb that has holes for the 16 pin PAL encoder so you can solder it to the back of the motherboard. That's one set of wires less at least This one's just a proof of concept, but I really like the small formfactor. In the mean time I have a V2.0 ready to be put together which has some small improvements in component lay-out.
Gerbers will be open source soon
New Videopac G7000 RGB mod
-
- Posts: 46
- Joined: Fri Jun 30, 2017 8:12 pm
- Location: The Netherlands