Does anyone have a pin out diagram for modding a PS2 rgb cable for use with a Guncon?
I have an Ultimarc PS2 vga cable with a vga breakout board. I just need to know which signal needs to go to the Guncon. I.e. Is it just composite sync or does it also need a video signal?
PS2 RGB pin-out diagram for Guncon
Re: PS2 RGB pin-out diagram for Guncon
Csync works just fine.
Re: PS2 RGB pin-out diagram for Guncon
You can plug into the tvs video out, use the PS2 green channel if running component or use the composite video from the PS2.
Luma probably works too.
Luma probably works too.
-
- Posts: 873
- Joined: Thu Sep 11, 2014 3:37 pm
Re: PS2 RGB pin-out diagram for Guncon
Thanks.Star1 wrote:Csync works just fine.
Just to confirm, are you saying to use just Csync on it's own? I.e. I don't connect the Guncon to any of the red, green and blue lines.
Re: PS2 RGB pin-out diagram for Guncon
Yes, that's it.
-
- Posts: 873
- Joined: Thu Sep 11, 2014 3:37 pm
Re: PS2 RGB pin-out diagram for Guncon
Thanks. That sounds simple enough.Star1 wrote:Yes, that's it.